Fire Alarms

The Series 65 Optical Smoke Detector uses light sensing technology to “see” smoke entering the chamber. The external detector moulding is identica...

The AlarmSense Optical Smoke Detector works using the light scatter principle. The detector changes to alarm state at a pre-set threshold of smoke...

The base can only be used with AlarmSense systems. It is fitted with electronic circuitry to monitor the presence of detectors and signals any una...

The Manual Call Point has been designed to operate on an AlarmSense two-wire loop. An alarm is initiated by pressing the resettable element, which...

The base is designed for use with conventional systems that have manual call points and detector bases on the same circuit. The base is fitted wit...

The XPERT 7 Base is a low insertion force base with stainless steel contacts allowing easy and quick installation.  Features: XPERT addressing X...

The AlarmSense Heat Detector (A1R) has a fixed upper limit, but in addition, measures the rate of increase in temperature. Features: Can be used...

The XP95 Optical Smoke Detector uses the light scatter principle to quickly and effectively detect a range of slow burning and smouldering fires. ...

An AlarmSense detectors can only be mounted into the AlarmSense Base. The base is used for installing detectors that do not require an integral so...

The Series 65 Heat Detector uses a dual thermistor network to monitor temperature.  Features: Can be used for applications where smoke detectors ...

The Transparent Hinged Cover has been designed to fit all Apollo manufactured Manual Call Points to provide protection against accidental operation.

The XP95 Heat Detector (A2S) monitors temperature by using a single thermistor which provides a count output proportional to the external air tempe...

XP95 Sounder Base with integral isolated mounting base. Designed for indoor use. Features: Two Apollo Tones EN54-3 Sounder Selectable Volumes 55...

The Manual Call Point is used to manually initiate an alarm signal on the fire detection system.  Features: EN 54-11 & EN 54-17 Certified Re...

The XP95 Heat Detector monitors temperature by using a single thermistor which provides a count output proportional to the external air temperature.

The base is designed to be used with AlarmSense systems only. It is supplied with a low or high volume setting and red or white caps are available...

The Manual Call Point is used to manually initiate an alarm signal on the fire detection system. Features: EN 54-11 Certified 'Plug and Play' te...

The Manual Call Point is used to manually initiate an alarm signal on the fire detection system.  Feature: EN 54-11 Certified Resettable operatin...

XP95 Open-Area Sounder with red body. Built-in isolator.  Features: EN54-3 Sounder Selectable Volumes 92dB (A), 100dB (A) XP95 (works on Discove...

The AlarmSense Open-Area Sounder VID is designed for use in open-areas. Features: Synchronised flashing red LED on sounder visual indicators and...

  XP95 Sounder VAD Base with integral isolated mounting base. Designed for indoor use. Features: Two-Tone EN54-3 Sounder Multiple Selectable Vol...

The Intelligent Input/Output Module is used to monitor single pole, volt free contact inputs and control relay output contacts. Features: EN 54-17...

The Series 65 Heat Detector monitors temperature by using a dual thermistor network which provides a voltage output proportional to the external ai...

  The Series 65 Heat Detector monitors temperature by using a dual thermistor network which provides a voltage output proportional to the external ...